How to remove Deodorant / Antiperspirant from Brick
First 60 seconds
Move fast, but move carefully. Scrape away the excess deodorant / antiperspirant from the brick, lifting solids off the surface without pressing them further in. Aluminum salts build up in layers and need an acid rinse to dissolve fully, and a fired clay material porous enough to pull stains in deep if they are left to soak.
What you'll need
- White vinegar
- Dish soap
- A soft nylon brush
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- White vinegar: mix one part vinegar with two parts water.
- Dish soap: mix a few drops with cold water into a light suds.
- A soft nylon brush: work in small circles, never against the grain.
- Rinse and blot dry with a clean cloth, then press with dry towels and change them until no more transfers onto the towel.
Do not do this
- Hot water as a first step. It spreads oil-based stains before they can be lifted.
- Scrubbing while dry. It grinds residue into the fibers instead of lifting it.
Common questions
Can I use hot water to remove deodorant / antiperspirant from brick?
Hot water is not usually necessary, but on brick it is safer to stay with cool water regardless, since a fired clay material porous enough to pull stains in deep if they are left to soak.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the deodorant / antiperspirant stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.