How to remove Butter from Brick
First 60 seconds
The first sixty seconds decide how this turns out. Scrape away the excess butter from the brick, lifting solids off the surface without pressing them further in. Milk fat solidifies as it cools, so chilling it briefly makes scraping cleaner, and a fired clay material porous enough to pull stains in deep if they are left to soak.
What you'll need
- Cornstarch or talcum powder
- Dish soap
- Baking soda
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- Cornstarch or talcum powder: bury the spot in powder to pull the oil out.
- Dish soap: mix a few drops with cold water into a light suds.
- Baking soda: make a paste with water and let it sit before brushing off.
- Rinse and blot dry with a clean cloth, then press with dry towels and change them until no more transfers onto the towel.
Do not do this
- Hot water as a first step. It spreads oil-based stains before they can be lifted.
- Rubbing the spot. It pushes the stain deeper and spreads it outward.
Common questions
Can I use hot water to remove butter from brick?
No. Heat sets this type of stain permanently, so always start with cold water and check the surface stays cool throughout treatment.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the butter stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.