How to remove Tar / Asphalt from Laminate Flooring
First 60 seconds
Move fast, but move carefully. Scrape away the excess tar / asphalt from the laminate flooring, lifting solids off the surface without pressing them further in. A petroleum-based residue that softens with a lubricant before it will lift instead of smear, and a plastic wear-layer over particleboard that swells if water seeps into the seams.
What you'll need
- WD-40 or a similar lubricant
- A dull knife or old gift card
- Dish soap
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- A dull knife or old gift card: scrape gently at a low angle, never digging in.
- Dish soap: mix a few drops with cold water into a light suds.
- Wipe clean with a damp cloth and dry the surface fully so no residue film is left behind.
Do not do this
- Hot water as a first step. It spreads oil-based stains before they can be lifted.
- Rubbing the spot. It pushes the stain deeper and spreads it outward.
- Any heat source (iron, hair dryer, tumble dryer). Heat on laminate flooring can bond the stain permanently or warp the material.
Common questions
Can I use hot water to remove tar / asphalt from laminate flooring?
Hot water is not usually necessary, but on laminate flooring it is safer to stay with cool water regardless, since a plastic wear-layer over particleboard that swells if water seeps into the seams.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the tar / asphalt stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.