How to remove Slime from Faux Fur
First 60 seconds
The first sixty seconds decide how this turns out. Scrape away the excess slime from the faux fur, lifting solids off the surface without pressing them further in. A glue-and-borax polymer that behaves like a rubbery gum and lifts best once hardened by cold, and a synthetic pile that mats down permanently if brushed the wrong way while damp.
What you'll need
- Ice cubes
- A dull knife or old gift card
- Rubbing alcohol
Step by step
- Test first: dab your chosen agent on a hidden corner of the faux fur and wait 2–3 minutes to confirm no discoloration.
- Ice cubes: hold ice in a bag against the spot to harden it.
- A dull knife or old gift card: scrape gently at a low angle, never digging in.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in.
- Rinse and blot dry with a clean cloth, then press with dry towels and change them until no more transfers onto the towel.
- If a visible mark remains after two attempts, stop — further scrubbing on this material risks permanent damage, and a professional cleaner is the safer next step.
Do not do this
- Warm water. It softens the material instead of hardening it for removal.
- Pulling or picking at fibers. This can tear delicate weaves.
- Any heat source (iron, hair dryer, tumble dryer). Heat on faux fur can bond the stain permanently or warp the material.
- Soaking the faux fur. Oversaturating this material causes water rings, warping, or permanent staining of its own.
Common questions
Can I use hot water to remove slime from faux fur?
Hot water is not usually necessary, but on faux fur it is safer to stay with cool water regardless, since a synthetic pile that mats down permanently if brushed the wrong way while damp.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the slime stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.