How to remove Shoe Scuff Marks from Granite
First 60 seconds
The first sixty seconds decide how this turns out. Scrape away the excess shoe scuff marks from the granite, lifting solids off the surface without pressing them further in. Rubber transfer marks that respond better to a solvent than to scrubbing with water alone, and dense and heat-resistant, but a sealed surface can still stain if liquid sits too long.
What you'll need
- Rubbing alcohol
- Dish soap
- WD-40 or a similar lubricant
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in.
- Dish soap: mix a few drops with cold water into a light suds.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- Rinse and blot dry with a clean cloth, then press with dry towels and change them until no more transfers onto the towel.
Do not do this
- Scrubbing while dry. It grinds residue into the fibers instead of lifting it.
- Chlorine bleach. It can react with the stain or the material and cause discoloration.
Common questions
Can I use hot water to remove shoe scuff marks from granite?
Hot water is not usually necessary, but on granite it is safer to stay with cool water regardless, since dense and heat-resistant, but a sealed surface can still stain if liquid sits too long.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the shoe scuff marks stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.