How to remove Oil-Based Paint from Laminate Flooring
First 60 seconds
Do not reach for a rag and start scrubbing yet. Blot — do not wipe the oil-based paint from the laminate flooring, working from the outside edge of the stain inward so it cannot spread any further. Solvent-based paint will not budge with water and hardens into a permanent film, and a plastic wear-layer over particleboard that swells if water seeps into the seams.
What you'll need
- WD-40 or a similar lubricant
- Dish soap
- Rubbing alcohol
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- Dish soap: mix a few drops with cold water into a light suds.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in.
- Wipe clean with a damp cloth and dry the surface fully so no residue film is left behind.
Do not do this
- Water on its own. This stain is not water-soluble and will just smear.
- Letting it fully cure. Once cured this becomes a solvent-only, often professional job.
- Any heat source (iron, hair dryer, tumble dryer). Heat on laminate flooring can bond the stain permanently or warp the material.
Common questions
Can I use hot water to remove oil-based paint from laminate flooring?
Hot water is not usually necessary, but on laminate flooring it is safer to stay with cool water regardless, since a plastic wear-layer over particleboard that swells if water seeps into the seams.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the oil-based paint stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.