How to remove Oil-Based Paint from Corduroy
First 60 seconds
The first sixty seconds decide how this turns out. Blot — do not wipe the oil-based paint from the corduroy, working from the outside edge of the stain inward so it cannot spread any further. Solvent-based paint will not budge with water and hardens into a permanent film, and the ridged pile crushes flat if pressed hard while wet, so blotting beats scrubbing.
What you'll need
- WD-40 or a similar lubricant
- Dish soap
- Rubbing alcohol
Step by step
- Test first: dab your chosen agent on a hidden corner of the corduroy and wait 2–3 minutes to confirm no discoloration.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- Dish soap: mix a few drops with cold water into a light suds.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in.
- Rinse and blot dry with a clean cloth, then press with dry towels and change them until no more transfers onto the towel.
Do not do this
- Water on its own. This stain is not water-soluble and will just smear.
- Letting it fully cure. Once cured this becomes a solvent-only, often professional job.
Common questions
Can I use hot water to remove oil-based paint from corduroy?
Hot water is not usually necessary, but on corduroy it is safer to stay with cool water regardless, since the ridged pile crushes flat if pressed hard while wet, so blotting beats scrubbing.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the oil-based paint stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.