How to remove Newsprint Ink from Polyester
First 60 seconds
Do not reach for a rag and start scrubbing yet. Blot — do not wipe the newsprint ink from the polyester, working from the outside edge of the stain inward so it cannot spread any further. A fine loose pigment that transfers on contact and smears wider with every rub, and a synthetic fiber that resists staining but heat can permanently melt-set a stain.
What you'll need
- Rubbing alcohol
- Dish soap
- Aerosol hairspray
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in.
- Dish soap: mix a few drops with cold water into a light suds.
- Aerosol hairspray: spray directly on the mark, then blot before it dries.
- Wipe clean with a damp cloth and dry the surface fully so no residue film is left behind.
Do not do this
- Hot or warm water. Heat cooks the stain into the fibers, making it permanent.
- Rubbing the spot. It pushes the stain deeper and spreads it outward.
- Any heat source (iron, hair dryer, tumble dryer). Heat on polyester can bond the stain permanently or warp the material.
Common questions
Can I use hot water to remove newsprint ink from polyester?
Hot water is not usually necessary, but on polyester it is safer to stay with cool water regardless, since a synthetic fiber that resists staining but heat can permanently melt-set a stain.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the newsprint ink stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.