How to remove Motor Oil from Glass Tabletop
First 60 seconds
The first sixty seconds decide how this turns out. Blot — do not wipe the motor oil from the glass tabletop, working from the outside edge of the stain inward so it cannot spread any further. Petroleum oils resist water and need an absorbent powder to pull them out first, and a fully non-porous surface where almost nothing bonds permanently if wiped up promptly.
What you'll need
- Cornstarch or talcum powder
- Dish soap
- Baking soda
- WD-40 or a similar lubricant
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- Cornstarch or talcum powder: bury the spot in powder to pull the oil out.
- Dish soap: mix a few drops with cold water into a light suds.
- Baking soda: make a paste with water and let it sit before brushing off.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- Wipe clean with a damp cloth and dry the surface fully so no residue film is left behind.
Do not do this
- Hot water as a first step. It spreads oil-based stains before they can be lifted.
- High-pressure rinsing right away. It drives the oil further into a porous surface.
Common questions
Can I use hot water to remove motor oil from glass tabletop?
Hot water is not usually necessary, but on glass tabletop it is safer to stay with cool water regardless, since a fully non-porous surface where almost nothing bonds permanently if wiped up promptly.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the motor oil stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.