How to remove Hair Gel / Pomade from Faux Leather
First 60 seconds
Move fast, but move carefully. Scrape away the excess hair gel / pomade from the faux leather, lifting solids off the surface without pressing them further in. A wax-and-polymer base that needs a solvent to break down before it will rinse out, and a plastic coating over fabric that resists soaking in but can crack under solvents.
What you'll need
- Dish soap
- Rubbing alcohol
- WD-40 or a similar lubricant
Step by step
- Test first: dab your chosen agent on a hidden corner of the faux leather and wait 2–3 minutes to confirm no discoloration.
- Dish soap: work a tiny amount into the spot on a barely-damp cloth, then wipe off immediately — do not saturate the material.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in — use sparingly, leather can dry out under repeated solvent contact.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- Wipe clean with a damp cloth and dry the surface fully so no residue film is left behind.
Do not do this
- Hot water as a first step. It spreads oil-based stains before they can be lifted.
- Rubbing the spot. It pushes the stain deeper and spreads it outward.
- Any heat source (iron, hair dryer, tumble dryer). Heat on faux leather can bond the stain permanently or warp the material.
Common questions
Can I use hot water to remove hair gel / pomade from faux leather?
Hot water is not usually necessary, but on faux leather it is safer to stay with cool water regardless, since a plastic coating over fabric that resists soaking in but can crack under solvents.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the hair gel / pomade stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.