How to remove Hair Gel / Pomade from Concrete
First 60 seconds
Move fast, but move carefully. Scrape away the excess hair gel / pomade from the concrete, lifting solids off the surface without pressing them further in. A wax-and-polymer base that needs a solvent to break down before it will rinse out, and highly porous and alkaline, so it can pull stains deep if not treated quickly.
What you'll need
- Dish soap
- Rubbing alcohol
- WD-40 or a similar lubricant
Step by step
- Gather your materials before you start — set out everything so you are not searching mid-treatment.
- Dish soap: work a tiny amount into the spot on a barely-damp cloth, then wipe off immediately — do not saturate the material.
- Rubbing alcohol: dab with alcohol on a cotton pad, working from the edge in.
- WD-40 or a similar lubricant: spray lightly, wait a minute, then wipe from the outside in.
- Rinse and blot dry with a clean cloth, then press with dry towels and change them until no more transfers onto the towel.
Do not do this
- Hot water as a first step. It spreads oil-based stains before they can be lifted.
- Rubbing the spot. It pushes the stain deeper and spreads it outward.
Common questions
Can I use hot water to remove hair gel / pomade from concrete?
Hot water is not usually necessary, but on concrete it is safer to stay with cool water regardless, since highly porous and alkaline, so it can pull stains deep if not treated quickly.
Is it safe to scrub the stain out?
Scrubbing usually makes things worse. Blot or lift instead of rubbing, working from the outer edge inward so the stain does not spread.
What if the hair gel / pomade stain has already dried?
A dried stain takes longer and may need repeated treatments, but the same agents still work — just re-wet the area gently first to reactivate the stain before treating it.